IO Routing Issue In Pro Tools
Posted: November 3rd, 2014, 5:36 pm
Has anyone ran into an issue where Pro Tools isn't updating the IO correctly? For example, I typically make a mono track, send it straight to an aux, and then to a print track. So it looks something like this:
Source Track - Input "No Input", Output "Bus 1"
Aux - Input "Bus 1", Output "Bus 2"
Print Track - Input "Bus 2", Output "Stereo Out"
When I set "Source Track's" output to "Bus 1" it sometimes sound phased, or muffled (I think this is dependant on what "Bus 2" is doing), but never as intended. If I then, simply switch the output routing to "Bus 2," then set it back to "Bus 1," the phasing/effect goes away and it sounds as intended. I've had this happen quite often from 10.8 through 11.
Has anyone else ran into this issue? I imagine it's some form of user error on my part with the IO setup, but this hasn't started happening to me until recently.
Thanks,
Mike
Source Track - Input "No Input", Output "Bus 1"
Aux - Input "Bus 1", Output "Bus 2"
Print Track - Input "Bus 2", Output "Stereo Out"
When I set "Source Track's" output to "Bus 1" it sometimes sound phased, or muffled (I think this is dependant on what "Bus 2" is doing), but never as intended. If I then, simply switch the output routing to "Bus 2," then set it back to "Bus 1," the phasing/effect goes away and it sounds as intended. I've had this happen quite often from 10.8 through 11.
Has anyone else ran into this issue? I imagine it's some form of user error on my part with the IO setup, but this hasn't started happening to me until recently.
Thanks,
Mike